C H A P T E R 3
Installing Ethernet Switching Modules
Revised: April 2012
This chapter describes how to safely install, remove, and verify the operation of the Ethernet switching modules in the Catalyst 6500 series switches, and it contains these sections:
•Safety, page
•Installing an Ethernet Switching Module, page
•Removing an Ethernet Switching Module, page
•Installing Pluggable Transceivers, page
•Attaching the Network Interface Cables, page
•Verifying the Installation, page
•What To Do After Installing Modules and Verifying Connectivity, page
Safety
Safety warnings appear throughout this publication in procedures that may harm you if performed incorrectly. A warning symbol precedes each warning statement. The warnings below are general warnings that are applicable to the entire publication.
Warning Class 1 laser product. Statement 1008
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030
Warning Before opening the unit, disconnect the
Catalyst 6500 Series Ethernet Modules Installation Guide
|
| ||
|
|