Chapter 1 Catalyst 6500 Series Switch Chassis Overview
Catalyst 6503 Switch
Table
Feature | Description |
|
|
Supervisor engines | • Supports Supervisor Engine 2, Supervisor Engine 32, Supervisor |
| Engine 32 PISA, and Supervisor Engine 720. |
| – Supervisor engines are installed in slot 1 and slot 2. |
| – Supervisor Engine 720 with |
| and |
| chassis. |
| – Supervisor Engine 32, Supervisor Engine 32 PISA, or Supervisor |
| Engine 720 requires that the optional |
| |
| – Supervisor Engine 720 has |
| Modules |
| supported by Supervisor Engine 720 and cannot be installed in the |
| same chassis. |
| – Supervisor Engine 32 and Supervisor Engine 32 PISA do not |
| support the Switch Fabric Modules |
| |
| • The uplink ports are fully functional on the redundant supervisor engine |
| while it is in standby mode. |
| Note In systems with redundant supervisor engines, both supervisor |
| engines must be the same model and have the same daughter card |
| configurations. Each supervisor engine must have the resources to |
| run the switch on its own, which means all supervisor engine |
| resources are duplicated. Identical supervisor engine memory |
| configurations are recommended, but are not required as long as the |
| supervisor engine with the smaller memory configuration is |
| sufficient to run the configured features of the switch. Additionally, |
| each supervisor engine must have its own flash device and console |
| port connections. |
|
|
Modules | • Supports up to two Catalyst 6500 series modules. |
| • Does not support the |
| Fabric Modules. |
| • Does not support the |
| • Some Catalyst 6500 series modules: |
| – Are not supported |
| – Require that you install a Supervisor Engine 720 |
| – Have chassis slot restrictions |
| – Require a specific software release level |
| Check your software release notes for specific information on module |
| support. |
|
|
Catalyst 6500 Series Ethernet Modules Installation Guide
|
| |
|