Cisco Systems 3200 Series manual Inserting the Card Stack into the Enclosure

Chapter 3 Replacing Cards in the Cisco ISR 3270 Rugged Enclosure

Card Replacement Process

Replacing or Adding a New Card

To replace or add new cards, follow the steps in the “Replacing or Adding a New Card” section on page 2-23.

Inserting the Card Stack into the Enclosure

To insert the card stack into the rugged enclosure, follow these steps:

Step 1 Make sure that the LED cable is connected to the back of the Fast Ethernet Switch Mobile Interface Card (FESMIC) and the serial console cable is connected to the back of the SMIC card. See Figure 3-6.

Figure 3-6 LED and Serial Console Cables

1 2

1

LED cable

270470

2Serial console cable

Step 2 Route the serial connector and (FESMIC) LED ribbon cables over the top of the stack.

Step 3 Align each cards’ Wedge Loks so that the angles on the Wedge Loks match the angle of the Wedge Lok rail. Figure 2-9shows proper Wedge Lok alignment.

Step 4 Place the extrusion vertically on a sturdy, flat surface with the antenna end cap side facing up.

Cisco 3200 Series Router Hardware Upgrade Guide

OL-15983-01 3-7