Cisco Systems 3200 Series manual Attaching Antenna Labels

Chapter 3 Replacing Cards in the Cisco ISR 3270 Rugged Enclosure

Card Replacement Process

Reattaching the Antenna End Cap

To reattach the antenna end cap, follow these steps:

Step 1 If you have added new WMICs, remove the corresponding antenna end cap plugs from the antenna end cap and replace them with RP-TNC connectors.

Step 2 Attach the antenna cables to the antenna end cap, as shown in Figure 2-2.

Step 3 Attach the antenna identification labels for the new WMICs on the antenna end cap’s exterior, as shown in Figure 3-16. (Figure 3-16shows one new label being applied over an old label.)

Figure 3-16 Attaching Antenna Labels

1

270479

1

Label

Step 4 Use a 3/8-inch socket to secure the antenna end cap with four 1/4-20 x 1 1/4-inch-long bolts. The torque range for the antenna end cap bolts is 58 to 68 in-lb.

	Cisco 3200 Series Router Hardware Upgrade Guide
3-16	OL-15983-01