Cisco Systems 3200 Series manual 11 0-WMIC Configuration

Chapter 3 Replacing Cards in the Cisco ISR 3270 Rugged Enclosure

Card Replacement Process

Reattaching the Wiring Card

To reattach the wiring card to the card stack, follow these steps:

Step 1 Attach the wiring card to the front of the card stack by aligning ports and firmly pressing the card into the stack.

Step 2 If WMICs are present, make sure that the WMIC mounting boss is within 0.01 inch of the wiring card.

Step 3 Using a Phillips screwdriver, tighten the wiring card screws using 5.5 to 5.7 in-lb torque, as shown in Figure 3-4.

Note In a 0-WMIC configuration, screw number 2 is not used.

Step 4 Connect the cables to the wiring card, as shown in Figure 3-11.

For a 0-WMIC configuration, connect the cables to the wiring card as shown in Figure 3-11.

Figure 3-11 0-WMIC Configuration

2

1

			3
			4
		270475
1	Connect the FESMIC 10-pin FE1X cable to	2		Connect the FESMIC 10-pin FE3X cable to
	port J14 on the wiring card.			port J16 on the I/O card.
3	Connect the FESMIC 10-pin FE2X cable to	4		Thread the FE extender cable under the card
	port J4 on the wiring card.			stack to the antenna end cap side.

For a 1-WMIC configuration, connect the cables to the wiring card as shown in Figure 3-12.

	Cisco 3200 Series Router Hardware Upgrade Guide
OL-15983-01		3-11