Cabletron Systems DELHE-UA manual Installing Fast Ethernet Port Interface Modules

Chapter 2: Installation

4.After removing the module from its antistatic bag, visually inspect the device. If you notice any sign of damage, contact a DIGITAL representative immediately. Save the antistatic bag in the event the module must be reshipped.

2.2INSTALLING FAST ETHERNET (PORT) INTERFACE MODULES

Only qualified personnel should perform installation procedures.

Fast Ethernet (Port) Interface Modules (FEPIMs) must be installed in the DELHE-UA before installing the DELHE-UA in the host device. The FEPIMs provide connectivity to the network. At least one FEPIM must be installed in either port one or port two. To install an FEPIM in the DELHE-UA, proceed as follows:

The DELF3-UI uses Class 1 lasers. Do not use optical instruments to view the laser output. The use of optical instruments to view laser output increases eye hazard. When viewing the output optical port, power must be removed from the network adapter.

The FEPIM and the DELHE-UA are sensitive to static

!discharges. Use an antistatic wrist strap and observe all static precautions during this procedure. Failure to do so could damage the FEPIM or the DELHE-UA.

1.Remove the coverplate from the port slot where the FEPIM will be installed.

To remove the coverplate, refer to Figure 2-1 and proceed as follows:

a.Remove the two screws fastening the coverplate to the standoffs. Save the screws.

b.Lift and remove the coverplate from the top of the front standoffs.

2-2 DELHE-UA User’s Guide