Cabletron Systems DELHE-UA manual Removing the Hsim Coverplate

Page 30

Chapter 2: Installation

5.Remove and save the two faceplate mounting screws securing the HSIM coverplate and remove the coverplate. See Figure 2-3.

DELHE-UA

Coverplate

Faceplate Mounting Screws

2555_03

Figure 2-3 Removing the HSIM Coverplate

6.Refer to Figure 2-4 and place the DELHE-UA behind the module faceplate.

2-6

DELHE-UA User’s Guide

Image 30
Contents DELHE-UA Page Digital Fast Ethernet Interface Module United States Government Restricted Rights Achtung Cabletron SYSTEMS, INC. Program License Agreement Page Declaration of Conformity Contents Contents Figures Tables Using this Guide PrefaceStructure of this Guide Document Conventions Related DocumentationWorld Wide Web CorrespondenceDocumentation Comments Getting HelpPage Safety OverviewSafety Requirements Safety Requirements Xviii DELHE-UA User’s Guide DELHE-UA User’s Guide Xix Das Ende an beiden Seiten des Chapter Introduction ConnectivityLocal Management Full Duplex Switched EthernetLanview Diagnostic LEDs Fepim OptionsChapter Installation Unpacking the DELHE-UAInstalling Fast Ethernet Port Interface Modules Installing Fast Ethernet Port Interface Modules Installing the Fepim Installing the DELHE-UA Installing the DELHE-UA in an Interface ModuleRemoving the Hsim Coverplate Installing the DELHE-UA Connecting to the Network Connecting a Fiber Optic Segment to the Fepim Connecting a Twisted Pair Segment to the DELTX-UI DELTX-UI Crossover Switch Straight-Through Cable Connecting to the Network Page Chapter DELHE-UA LEDsDELTX-UI LED ChapterDELHE-UA Local Management DELHE-UA Local ManagementPage Appendix a DELHE-UA Specifications Physical PropertiesEnvironmental Requirements Regulatory Compliance Appendix B Fepim Specifications DELTX-UIDELFX-UI DELF3-UI Page Page 9032765