Cabletron Systems SSIM-H2-02 manual FCC Notice, Vcci Notice, Industry Canada Notice

Page 3

ii

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

VCCI Notice

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

Industry Canada Notice

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

Notice

Image 3
Contents Page Order Number 9032962-01 OC-7063 v .1 FCC Notice Vcci NoticeIndustry Canada Notice Declaration of Conformity Addendum IiiApplication of Council Directives 89/336/EEC 73/23/EEC Page Table of Contents Statistics Vii List of FiguresViii List of TablesIntroduction SSIM-H2-02 Switch SmartStack Interface ModuleFeature Description Processor on the SmartStack STS16-20RM This makes it possible to configure the devicePart of the LAN switch Snmp is supported via the host processorFEUplink MIB MIB SupportPackage Contents InstallationInstallation Procedure Removing the Expansion Slot Cover Hardware InstallationTftp Download Software InstallationFrom the main menu, select Download→ Upload Serial DownloadLEDs CablingPower-On Self Test Default Configuration ConfigurationConfiguration Ports, Port Groups and VLANs IntroductionTS Virtual Ports and Vlan Tagging Virtual Port RestrictionRing Number Restriction Source Routed Switching SRS Operation Mode Source Routed Transparent Bridging SRT ModeBridging Modes Ethernet CRF in SRB Bridging Mode Source Routed Bridging SRB ModeRedundant Connections to Fast Ethernet Network Network ScenariosPreventing Frame Duplication Frame Looping Preventing Frame LoopingBroken Ethernet Cloud Spanning Tree ConfigurationRedundant Connections to Fast Ethernet Network Page Technical Background STP Cost Modification General Guidelines Navigating Within the Menus Main Switch MenuConfiguration Overview Local Vlan Port Configuration Vlan ConfigurationPort Configuration TS Ports BRF ConfigurationAddress Demand Aging Level Virtual Port ConfigurationStatus Display only. Shows the current status of the port1558 001 DefaultDisplay only. Shows the current status of the virtual port You can use only one value as MTURIF Not Learn Interval Vlan Tagging ModeFC Modification Address Aging TimeFrame Conversion Configuration IP Conversion StatusIP Conversion Parameters Change Snap Frame in the Ieee 802.3 format with Snap Default SRIP Ethernet Format Sets the format of IP frames on EthernetTR MAC Address for IP Multicasts Enable IP FragmentationNovell Conversion Status Explorer Frames TypeNovell Ethernet Format Novell Conversion Parameters ChangeNovell Frames Conversion Novell Token Ring FormatIPX Address Translation NetBios Conversion StatusNetBios Conversion Parameters Change NetBios Frames ConversionNetBios Ethernet Format NetBios Token Ring FormatSNA Conversion Parameters Change SNA Conversion StatusSets the format of SNA frames on Ethernet SNA Ethernet FormatOther Frames w/SNAP Token Ring Format Other Frames w/SNAP Conversion StatusOther Frames w/SNAP Conversion Parameters Change Other Frames w/SNAP Frames ConversionOther Frames w/SNAP Ethernet Format Other Frames w/o Snap Conversion StatusOther Frames w/o Snap Ethernet Format Other Frames w/o Snap Conversion Parameters ChangeOther Frames w/o Snap Frames Conversion Other Frames w/o Snap Token Ring FormatDual Home FEP Addresses Configuration Page Statistics Statistics Menu Port Status General Statistics Port StatisticsDiscarded Frames Table Blocked Virtual Port Table Filtered by Address FilterTable Filtered by Dsap Filter Locally FilteredTraffic Counters Error Counters Frames Forwarded Virtual Port StatisticsDiscarded Frames Statistics Virtual Port StateOther w/o Snap NetBiosInbound Translation errors Other w/SNAPOutbound No Translation Outbound Translation ErrorsGeneric w/o Snap Fragmentation ErrorYour email address Getting in Touch with Technical SupportPage Appendix A. Abbreviations Translational Switch Service Access PointSub-Network Access Protocol Source Route SwitchingIndex-1 IndexIndex-2 Local Vlan port configuration710001816