27
Configuration Overview
Execute the following general steps to configure a
•
•
•
•
•
•
•
•
Determine which VLANs the TS ports should connect.
Determine which VLAN, if any, should be untagged.
Configure the TS VLAN ID for all the BRFs that should be tagged.
Make sure that each TS VLAN ID matches that of the TS equipment at the other end.
Assign CRFs to the TS port, thereby creating one virtual port in each VLAN. Optional: create new CRFs to make sure that the CRFs do not have conflicting ring numbers, as discussed in the “Ring Number Restriction” on page 15.
Configure the virtual ports, in particular the tagging mode. The relevant configuration menus are described in detail in the following sections.
Configure the translational bridging parameters for each Virtual Port.
Assign CRFs to the TS port, thereby creating one virtual port in each VLAN. You may want to create new CRFs to ensure that the CRFs do not have conflicting ring numbers (see “Ring Number Restriction” on page 15). Remember that each CRF ring number must be set manually if automatic ring number learning is impossible.
Configuration |