Cabletron Systems 7F06-02 manual Transmitter power parameters are listed in Table

Page 13

NETWORK REQUIREMENTS

Transmitter power parameters are listed in Table 2-2.

Table 2-2. Transmitter Power Parameters

		Typical	Worst	Worst	Typical
	Parameter	Typical	Worst	Case	Typical
	Parameter	Value	Case	Case	Budget
		Value	Case	Budget	Budget
				Budget


	50/125 ∝m	-13.0 dBm	-15.0 dBm	13.0 dB	17.5 dB
	ﬁber

	62.5/125	-10.0 dBm	-12.0 dBm	16.0 dB	20.5 dB
	∝m ﬁber

	100/140	-7.0 dBm	-9.0 dBm	19.0 dB	23.5 dB
	∝m ﬁber

	Error Rate	Better than
		10-10

The link distance is up to 2 kilometers on the multimode ﬁber- optic cable as speciﬁed by ANSI MMF-PMD.

2-2

Image 13

Contents 7F06-02 Fddi SmartSWITCH Interface Module User’s Guide Page FCC Notice Vcci Notice Contents Contents Chapter Introduction Using this ManualCable Type and FPIMs 7F06-02 ModuleF06-02 Module FPIMs FeaturesLanview LEDs ConnectivityGetting Help Related ManualsChapter Network Requirements Fpim Module SpecificationsFPIM-00 and FPIM-01 Transmitter power parameters are listed in Table FPIM-02 and FPIM-04 Parameter Typical Minimum Maximum FPIM-05 and FPIM-07Installing Fpims Chapter INSTALLATION/REMOVALUnpacking the 7F06-2 Module Installing in the 7C03 SmartSwitch INSTALLING/REMOVING the 7F06-02 ModuleInstalling the 7F06-02 Module 7C03 Mmac SmartSwitch Removing from the7C03 SmartSwitchEjector Installing in the 7C04 or 7C04-R Workgroup SmartSwitch Fans Removing from the 7C04 or 7C04-R Workgroup SmartSwitch INSTALLATION/REMOVAL Shows the Lanview LEDs of the 7F06-02 Module Chapter TroubleshootingIndicates the state of the receive port Indicates the state of the A/B Link LEDs Standards Chapter Technical SpecificationsEMI EMCService SafetyDimensions Weight