Cabletron Systems 7F06-02 manual Installing in the 7C04 or 7C04-R Workgroup SmartSwitch

Page 20

INSTALLATION/REMOVAL

3.3.3Installing in the 7C04 or 7C04-R Workgroup SmartSwitch

The 7F06-02 Module is installed in the 7C04 or 7C04-R Workgroup SmartSwitch using the following steps and referring to the appropriate figure.

Notes: The top slot in the 7C04 Workgroup SmartSwitch is reserved for the 7X00 SmartSwitch Module.

The bottom slot in the 7C04-R Workgroup SmartSwitch is reserved for the 7X00 SmartSwitch Module.

Before installing the 7F06-02 module, attach the wrist strap included with the SmartSwitch or SmartSwitch module by following the instructions printed on the package.

1.Remove the blank panel covering the slot in which the module will be installed. All other slots must remain covered to ensure proper airflow and cooling.

2.Install the module by sliding it into slots as shown in the appropriate figure. Ensure that the printed circuit board (PCB) is between the card guides, slides in straight, and engages the backplane connectors properly.

3.Using a slotted screwdriver, tighten the top and bottom screws.

3-5

Page 19 Page 21
Image 20
Page 19 Page 21
Contents 7F06-02 Fddi SmartSWITCH Interface Module User’s Guide Page FCC Notice Vcci Notice Contents Contents Using this Manual Chapter Introduction7F06-02 Module Cable Type and FPIMsF06-02 Module Features FPIMsLanview LEDs ConnectivityRelated Manuals Getting HelpFPIM-00 and FPIM-01 Fpim Module SpecificationsChapter Network Requirements Transmitter power parameters are listed in Table FPIM-02 and FPIM-04 FPIM-05 and FPIM-07 Parameter Typical Minimum MaximumUnpacking the 7F06-2 Module Chapter INSTALLATION/REMOVALInstalling Fpims INSTALLING/REMOVING the 7F06-02 Module Installing in the 7C03 SmartSwitchRemoving from the7C03 SmartSwitch Installing the 7F06-02 Module 7C03 Mmac SmartSwitchEjector Installing in the 7C04 or 7C04-R Workgroup SmartSwitch Fans Removing from the 7C04 or 7C04-R Workgroup SmartSwitch INSTALLATION/REMOVAL Chapter Troubleshooting Shows the Lanview LEDs of the 7F06-02 ModuleIndicates the state of the receive port Indicates the state of the A/B Link LEDs Chapter Technical Specifications StandardsEMI EMCSafety ServiceDimensions Weight
Top Page Image Contents