Cabletron Systems manual 7F06-02 Module, Cable Type and FPIMs

Page 8

INTRODUCTION

1.2 THE 7F06-02 MODULE

The 7F06-02 Module provides two Fiber Optic ports via front panel FPIM modules.

1.2.1 Cable Type and FPIMs

The 7F06-02 module has two front panel connectors that interface to the 7X00 Smart Switch Module through the chassis backplane. The front panel connections are standard Cabletron FPIMs. There are two FPIMs for each channel. These FPIMs allow the use of single mode or multimode ﬁber cable with MIC or SC type connectors and twisted pair cable, either shielded or unshielded.

1-2

Image 8

Contents 7F06-02 Fddi SmartSWITCH Interface Module User’s Guide Page FCC Notice Vcci Notice Contents Contents Using this Manual Chapter Introduction7F06-02 Module Cable Type and FPIMsF06-02 Module Features FPIMsLanview LEDs ConnectivityRelated Manuals Getting HelpFPIM-00 and FPIM-01 Fpim Module SpecificationsChapter Network Requirements Transmitter power parameters are listed in Table FPIM-02 and FPIM-04 FPIM-05 and FPIM-07 Parameter Typical Minimum MaximumUnpacking the 7F06-2 Module Chapter INSTALLATION/REMOVALInstalling Fpims INSTALLING/REMOVING the 7F06-02 Module Installing in the 7C03 SmartSwitchRemoving from the7C03 SmartSwitch Installing the 7F06-02 Module 7C03 Mmac SmartSwitchEjector Installing in the 7C04 or 7C04-R Workgroup SmartSwitch Fans Removing from the 7C04 or 7C04-R Workgroup SmartSwitch INSTALLATION/REMOVAL Chapter Troubleshooting Shows the Lanview LEDs of the 7F06-02 ModuleIndicates the state of the receive port Indicates the state of the A/B Link LEDs Chapter Technical Specifications StandardsEMI EMCSafety ServiceDimensions Weight