Cabletron Systems 7F06-02 manual FCC Notice

Page 3

Notice

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

DOC NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

ii

Image 3
Contents 7F06-02 Fddi SmartSWITCH Interface Module User’s Guide Page FCC Notice Vcci Notice Contents Contents Chapter Introduction Using this ManualCable Type and FPIMs 7F06-02 ModuleF06-02 Module Connectivity FeaturesFPIMs Lanview LEDsGetting Help Related ManualsFpim Module Specifications Chapter Network RequirementsFPIM-00 and FPIM-01 Transmitter power parameters are listed in Table FPIM-02 and FPIM-04 Parameter Typical Minimum Maximum FPIM-05 and FPIM-07Chapter INSTALLATION/REMOVAL Installing FpimsUnpacking the 7F06-2 Module Installing in the 7C03 SmartSwitch INSTALLING/REMOVING the 7F06-02 ModuleInstalling the 7F06-02 Module 7C03 Mmac SmartSwitch Removing from the7C03 SmartSwitchEjector Installing in the 7C04 or 7C04-R Workgroup SmartSwitch Fans Removing from the 7C04 or 7C04-R Workgroup SmartSwitch INSTALLATION/REMOVAL Shows the Lanview LEDs of the 7F06-02 Module Chapter TroubleshootingIndicates the state of the receive port Indicates the state of the A/B Link LEDs EMC Chapter Technical SpecificationsStandards EMIWeight SafetyService Dimensions