Cabletron Systems 7F06-02 manual FPIM-05 and FPIM-07, Parameter Typical Minimum Maximum

Page 15

NETWORK REQUIREMENTS

2.1.3 FPIM-05 and FPIM-07

The FPIM-05 and FPIM-07 provide a Single-mode ﬁber connection. The FPIM-05 uses a MIC style connector and the FPIM-07 uses an SC type connector. The speciﬁcations for both devices are listed in Table 2-4.

Table 2-4. FPIM-05 and FPIM-07 Speciﬁcations

Parameter	Typical	Minimum	Maximum


Transmitter Peak	1300 nm	1270 nm	1330 nm
Wave Length

Spectral Width	60 nm	-	100 nm

Rise Time	3.0 nsec	2.7 nsec	5.0 nsec

Fall Time	2.5 nsec	2.2 nsec	5.0 nsec

Duty Cycle	50.1%	49.6%	50.7%

Bit Error Rate	Better
	than 10-10

The link distance is up to 40 kilometers (max) and 25 kilometers (typical) on single mode ﬁber-optic cable as speciﬁed by ANSI SMF-PMD.

2-4

Image 15

Contents 7F06-02 Fddi SmartSWITCH Interface Module User’s Guide Page FCC Notice Vcci Notice Contents Contents Chapter Introduction Using this ManualCable Type and FPIMs 7F06-02 ModuleF06-02 Module Connectivity FeaturesFPIMs Lanview LEDsGetting Help Related ManualsFpim Module Specifications Chapter Network RequirementsFPIM-00 and FPIM-01 Transmitter power parameters are listed in Table FPIM-02 and FPIM-04 Parameter Typical Minimum Maximum FPIM-05 and FPIM-07Chapter INSTALLATION/REMOVAL Installing FpimsUnpacking the 7F06-2 Module Installing in the 7C03 SmartSwitch INSTALLING/REMOVING the 7F06-02 ModuleInstalling the 7F06-02 Module 7C03 Mmac SmartSwitch Removing from the7C03 SmartSwitchEjector Installing in the 7C04 or 7C04-R Workgroup SmartSwitch Fans Removing from the 7C04 or 7C04-R Workgroup SmartSwitch INSTALLATION/REMOVAL Shows the Lanview LEDs of the 7F06-02 Module Chapter TroubleshootingIndicates the state of the receive port Indicates the state of the A/B Link LEDs EMC Chapter Technical SpecificationsStandards EMIWeight SafetyService Dimensions