Cabletron Systems 7F06-02 manual Removing from the7C03 SmartSwitch

INSTALLATION/REMOVAL

Notes: The left most slot in the 7C03 MMAC SmartSwitch is reserved for the 7X00 SmartSwitch Module.

Before installing the 7F06-02 module, attach the wrist strap included with the SmartSwitch or SmartSwitch module by following the instructions printed on the package.

1.Remove the blank panel covering the slot in which the module will be installed. All other slots must remain covered to ensure proper airflow and cooling.

2.Install the module by sliding it into slots as shown in Figure 3-2. Ensure that the printed circuit board (PCB) is between the card guides, slides in straight, and engages the backplane connectors properly.

3.Using a slotted screwdriver, tighten the top and bottom screws.

SN

TPR TPRMI

Card

Guides

Figure 3-2. Installing the 7F06-02 Module in the

7C03 MMAC SmartSwitch

3.3.2 Removing from the7C03 SmartSwitch

The 7F06-02 Module inserted in the 7C03 MMAC SmartSwitch can be removed whenever necessary. Follow the steps below and refer to Figure 3-3 to remove the module.

3-3