Cabletron Systems INSTALLING/REMOVING the 7F06-02 Module, Installing in the 7C03 SmartSwitch

Page 17

INSTALLATION/REMOVAL

Figure 3-1. Installing an FPIM

3.3 INSTALLING/REMOVING THE 7F06-02 MODULE

The following procedure detail the installing and removal procedure for the 7F06-02 module.

3.3.1 Installing in the 7C03 SmartSwitch

The 7F06-02 Module is installed in the 7C03 MMAC SmartSwitch using the following steps and referring to Figure 3-2.

3-2

Image 17

Contents 7F06-02 Fddi SmartSWITCH Interface Module User’s Guide Page FCC Notice Vcci Notice Contents Contents Chapter Introduction Using this ManualCable Type and FPIMs 7F06-02 ModuleF06-02 Module FPIMs FeaturesLanview LEDs ConnectivityGetting Help Related ManualsFPIM-00 and FPIM-01 Fpim Module SpecificationsChapter Network Requirements Transmitter power parameters are listed in Table FPIM-02 and FPIM-04 Parameter Typical Minimum Maximum FPIM-05 and FPIM-07Unpacking the 7F06-2 Module Chapter INSTALLATION/REMOVALInstalling Fpims Installing in the 7C03 SmartSwitch INSTALLING/REMOVING the 7F06-02 ModuleInstalling the 7F06-02 Module 7C03 Mmac SmartSwitch Removing from the7C03 SmartSwitchEjector Installing in the 7C04 or 7C04-R Workgroup SmartSwitch Fans Removing from the 7C04 or 7C04-R Workgroup SmartSwitch INSTALLATION/REMOVAL Shows the Lanview LEDs of the 7F06-02 Module Chapter TroubleshootingIndicates the state of the receive port Indicates the state of the A/B Link LEDs Standards Chapter Technical SpecificationsEMI EMCService SafetyDimensions Weight