Cabletron Systems 7F06-02 manual Ejector

INSTALLATION/REMOVAL

Note: Before removing the 7F06-02 module, attach the wrist strap included with the SmartSwitch or SmartSwitch module by following the instructions printed on the package.

1.Use a slotted screwdriver to loosen the two screws that secure the module to the chassis.

2.Locate the two ejector tabs on the module (to the right of the screws on the top and bottom of the module).

3.Simultaneously press down on the bottom ejector tab and up on the top ejector tab until the module ejects from the backplane.

4.Grasp both ejector tabs and carefully slide the module out of the chassis.

Screws

7X00	7F00			7E03-24
				SN
PWR	CPU
SN			A
MAC ADR
	F
	D	SN
	D	P	A
	I	S	B
	1			Ejector
			B
		P	A	Tabs
		S	B
			A
	F
	D
	D	P	A
		S	B
	I
	2
			B

Figure 3-3. Removing the 7F06-02 Module from the 7C03 MMAC

SmartSwitch

3-4