Cabletron Systems 7F06-02 manual FPIM-02 and FPIM-04

Page 14

NETWORK REQUIREMENTS

2.1.2 FPIM-02 and FPIM-04

The FPIM-02 has an RJ-45 connector supporting an Unshielded Twisted Pair (UTP) connection. The FPIM-04 has an RJ-45 connector supporting a Shielded Twisted Pair (STP) connection. The pinouts for both are listed in Table 2-3.

Table 2-3. FPIM-02 and FPIM-04 Pinouts

Pin Number	Represents	Pin Number	Represents


1	Transmit+	5	NA

2	Transmit-	6	NA

3	NA	7	Receive+

4	NA	8	Receive-

The link distance is up to 100 meters on unshielded twisted pair cable as speciﬁed by ANSI TP-PMD.

2-3

Image 14

Contents 7F06-02 Fddi SmartSWITCH Interface Module User’s Guide Page FCC Notice Vcci Notice Contents Contents Using this Manual Chapter Introduction7F06-02 Module Cable Type and FPIMsF06-02 Module Lanview LEDs FeaturesFPIMs ConnectivityRelated Manuals Getting HelpFPIM-00 and FPIM-01 Fpim Module SpecificationsChapter Network Requirements Transmitter power parameters are listed in Table FPIM-02 and FPIM-04 FPIM-05 and FPIM-07 Parameter Typical Minimum MaximumUnpacking the 7F06-2 Module Chapter INSTALLATION/REMOVALInstalling Fpims INSTALLING/REMOVING the 7F06-02 Module Installing in the 7C03 SmartSwitchRemoving from the7C03 SmartSwitch Installing the 7F06-02 Module 7C03 Mmac SmartSwitchEjector Installing in the 7C04 or 7C04-R Workgroup SmartSwitch Fans Removing from the 7C04 or 7C04-R Workgroup SmartSwitch INSTALLATION/REMOVAL Chapter Troubleshooting Shows the Lanview LEDs of the 7F06-02 ModuleIndicates the state of the receive port Indicates the state of the A/B Link LEDs EMI Chapter Technical SpecificationsStandards EMCDimensions SafetyService Weight