Telect MIX 56 user manual Installing MIX, Attaching the Mounting Brackets

MIX 56 User Manual 2 Installation

1-800-551-4567 or 1-509-926-6000

Keep the container until you have checked equipment operation. If you ex- perience any kind of problem, call Telect’s Customer Service Department. Use the original, undamaged container if you are instructed to return the MIX 56 to Telect.

INSTALLING MIX 56

These procedures may be modified to agree with site practices or operating company procedures.

NOTE

If you are installing the optional MIX 56 Broadband Sidecar

(PN 747-9999-2001), read the installation instructions included with the kit before installing the MIX 56 chassis.

Attaching the Mounting Brackets

When attaching the mounting brackets, you can set the chassis to project 3, 4, or 5 inches from the front of the rack, depending on which set of holes on the chassis you choose. The following illustration shows the standard bracket being installed for 3-inch projection. To allow more front projec- tion, use the middle set of holes for 4 inches or the last set of holes for 5 inches.

NOTE

If you are mounting the chassis in a 23-inch rack, use the included extender bracket shown in the illustration on the next page.

Step Action

1.Select the appropriate brackets (included) for the rack size, standard for 19 in. racks or extender for 23 in. racks.

2.On one side of the chassis, insert two of the included #8-32 screws through the bracket screw holes and into the bracket mounting holes on the chassis, as shown in the illustration on the next page. Choose holes that correspond to the desired front projection.

122188-10 A0 Telect, Inc. 2-5