Telect MIX 56 user manual Software Operation, Managing a System

4 Software Operation

MANAGING A SYSTEM

You can configure, test, and monitor a system using these interfaces:

•Via Ethernet Port located on rear of chassis (one per system):

◊SNMP (Simple Network Management Protocol) Interface

◊Craft Interface over Telnet connection (up to two Telnet sessions)

◊TL1 Interface over Telnet connection (up to two Telnet sessions)

•Via Craft Port (serial port) on front of chassis (one per system):

◊Craft Interface over RS232 serial connection

◊TL1 Interface over RS232 serial connection

•Via Remote Control:

If the MIX 56 is connected over the DS3 link to another MIX 56 and they are both in C-bit mode on the DS3 link, then a remote control ses- sion can be run where the user is controlling the MIX 56 at the remote end of the DS3 link.

◊Craft Interface over DS3 Link

◊TL1 Interface over DS3 Link

! ALERT

ALERT! It is possible to have multiple active sessions at the same time involved in configuring the same system. It is possi- ble to have five active sessions at the same time: one via the serial port; two via Telnet connections; one SNMP; and one via Remote Control.

122188-10 A0 Telect, Inc. 4-1