MIX 56 User Manual | 4 Software Operation |
MIX 56 by Telect | Rt. Mix56 | Directory (CTRL+D) | |
| Loopbacks | Help (?) | |
|
| ||
LS Chan #: 1 | [Apply] | ||
Rx: None | |||
High Speed: None |
| ||
Low Speed: None | Rx: None |
|
=============================================================================
# | Name | DS3 DS1 Status | Rx | # | Name | DS3 | DS1 Status | Rx |
15 | Low Speed 15 None | Chan.Disabled... | ||||||
2 | Low Speed 02 | None None | No | 16 | Low Speed 16 None | Chan.Disabled... | ||
3 | Low Speed 03 | None Chan.Disabled... | 17 | Low Speed 17 None | Chan.Disabled... | |||
4 | Low Speed 04 | None Chan.Disabled... | No | 18 | Low Speed 18 None | Chan.Disabled... | ||
5 | Low Speed 05 | None None | 19 | Low Speed 19 None | Chan.Disabled... | |||
6 | Low Speed 06 | None None | No | 20 | Low Speed 20 | ..... | Chan.Unavail.... | |
7 | Low Speed 07 | None Chan.Disabled... | 21 | Low Speed 21 None | Chan.Disabled... | |||
8 | Low Speed 08 | .....Chan.Unavail.... | 22 | Low Speed 22 None | Chan.Disabled... | |||
9 | Low Speed 09 | None Chan.Disabled... | 23 | Low Speed 23 None | Chan.Disabled... | |||
10 | Low Speed 10 | None Chan.Disabled... | 24 | Low Speed 24 None | Chan.Disabled... | |||
11 | Low Speed 11 | None Chan.Disabled... | 25 | Low Speed 25 None | Chan.Disabled... | |||
12 | Low Speed 12 | None Chan.Disabled... | 26 | Low Speed 26 None | Chan.Disabled... | |||
13 | Low Speed 13 | None Chan.Disabled... | 27 | Low Speed 27 None | Chan.Disabled... | |||
14 | Low Speed 14 | None Chan.Disabled... | 28 | Low Speed 28 None | Chan.Disabled... | |||
2.In the LS Chan # field, type the number of the low speed channel you want to run a loopback on, and then press Enter.
If the selected channel is disabled, “Chan Disabled” will appear in the Low Speed field. If the selected channel is unavailable, “Chan Unavail.” will appear in the Low Speed field.
3.Tab to the High Speed field, select a loopback by pressing the spa- cebar to toggle among “Local , DS3”, “Line, DS3”, “Line DS1 Ch xx in DS3”, “Remove DS1 Ch xx in DS3”, “Remote All DS1’s in DS3”, “Remote DS3 (Line)”, or “None”; and then press Enter.
None means a loopback is not running, and therefore, the channel is operating normally.
4.Tab to the Low Speed field, select a loopback to run on the channel by pressing the spacebar to toggle among “Local, Line”, “Remote Tx LpUp”, “Remote Tx LpDn”, or “None”; and then press Enter.
If the Low Speed Channel is disabled or unavailable, the Low Speed field is not enabled.
5.Tab to the [Apply] button and press Enter. A prompt appears asking you to confirm running the loopbacks. The [Apply] button is not enabled until a change in either the “High Speed” or “Low Speed” field is made.
Telect, Inc. |
