
4 Software Operation | MIX 56 User Manual |
6.Type y and press Enter. The High Speed field in the upper frame displays the loopback running on the High Speed circuit. The lower frame displays the status of the Low Speed channels.
NOTES
•The Rx fields on the Loopback screeen is to display the status of the MIX 56 receiving any remote loopback requests.
•The DS3 column on the Loopback screen’s lower frame displays the status of the loopback that is currently set on the corresponding DS1 channel of the MUXed DS3 signal. This DS3 field will display either “Line” or “Rem”.
BER TESTING
The MIX 56 has a limited set of Bit Error Rate (BER) testing capabilities. This BER testing is setup from the Craft interface screen 20, “BER Test- ing”. In the “BER Testing” screen you can specify test mode and test pat- tern.
The test mode specifies where the test is to be performed. This allows you to select either a
The test pattern selections are dependant on which test mode is selected. The test patterns available for the different modes are specified in the fol- lowing table:
Mode |
| Available Patterns |
1. | Pseudorandom test, PBRS | |
This test puts a | 2. | Pseudorandom test, PBRS |
3. | Pseudorandom test, PBRS | |
the DS3 high speed line |
|
|
T1/E1 Test on High Speed Line | 1. | Pseudorandom test, PBRS |
This test puts either a T1 or E1 test signal | 2. | Pseudorandom test, PBRS |
3. | Pseudorandom test, PBRS | |
onto a specific channel of the Muxed DS3 | 4. | Quasi_Random test, PBRS (QRSS) |
signal on the DS3 high speed line | 5. | All Ones |
| ||
| 6. | All Zeros |
| 7. | 3 in 24 |
| 8. | 1 in 8 (1:7) |
Unframed Test on Low Speed Line | 1. | Pseudorandom test, PBRS |
This test puts an unframed T1 or E1 test | 2. | Quasi_Random test (QRSS) |
|
| |
signal onto a specific low speed line |
|
|
|
|
|
Telect, Inc. |