MIX 56 User Manual

1 Descriptions

Ethernet Port: One per system. RJ-45 10Base-T (half-duplex) connector with two LEDs. Interface for managing system remotely via either SNMP or Telnet. When lit, green LED means valid link pulse detected and flash- ing yellow LED means traffic in either direction.

NOTE

Before using the Ethernet port, you must connect to the local craft interface through the Craft port and set the system’s IP and Subnet Mask addresses in the System Interfaces screen. See “Specifying System Interface Settings” on page 4-17.

Power Receptacle: One per system (20Vdc to 60Vdc). Four-position con- nector (14-22 AWG) used to supply redundant (A, B) power to the system.

The power connector may be a wire-clamping, screw-type terminal or a two-piece mated connector.

Logic and Coaxial Shield Ground: One per system. Three-position DIP switch. Used to connect logic ground, DS3 shield TX ground, and DS3 shield RX ground to chassis ground:

on = connected to chassis ground

off = disconnected from chassis ground

M13 Card

Dimensions

9.60 in.

4.75 in.(24.38 cm)

(12.07 cm)

LED Status

Indicator

Width = .06 in.

(.16 cm)

Part # 747-1001-0000

122188-10 A0

Telect, Inc.

1-7

Page 17
Image 17
Telect MIX 56 user manual M13 Card, Dimensions