Cabletron Systems 7F06-02 manual Indicates the state of the receive port

Page 25

TROUBLESHOOTING

Table 4-1 indicates the state of the receive port.

	Table 4-1. Port Receive LEDs

LED Color		State

Yellow (Flashing)		Data activity (ﬂashing to steady on
		indicates rate)

Off		No activity, port can be disabled or
		enabled

Table 4-2 indicates the state of the transmit port.

	Table 4-2. Port Transmit LEDs

LED Color		State


Green (Flashing)		Data activity (ﬂashing to steady on
		indicates rate)

Off		No activity, port can be disabled or
		enabled

4-2

Image 25

Contents 7F06-02 Fddi SmartSWITCH Interface Module User’s Guide Page FCC Notice Vcci Notice Contents Contents Chapter Introduction Using this ManualCable Type and FPIMs 7F06-02 ModuleF06-02 Module FPIMs FeaturesLanview LEDs ConnectivityGetting Help Related ManualsChapter Network Requirements Fpim Module SpecificationsFPIM-00 and FPIM-01 Transmitter power parameters are listed in Table FPIM-02 and FPIM-04 Parameter Typical Minimum Maximum FPIM-05 and FPIM-07Installing Fpims Chapter INSTALLATION/REMOVALUnpacking the 7F06-2 Module Installing in the 7C03 SmartSwitch INSTALLING/REMOVING the 7F06-02 ModuleInstalling the 7F06-02 Module 7C03 Mmac SmartSwitch Removing from the7C03 SmartSwitchEjector Installing in the 7C04 or 7C04-R Workgroup SmartSwitch Fans Removing from the 7C04 or 7C04-R Workgroup SmartSwitch INSTALLATION/REMOVAL Shows the Lanview LEDs of the 7F06-02 Module Chapter TroubleshootingIndicates the state of the receive port Indicates the state of the A/B Link LEDs Standards Chapter Technical SpecificationsEMI EMCService SafetyDimensions Weight