Cabling the Enclosure

Bottom Panel Features

3 5

Figure 8. HSA 822 Enclosure Underside Connectors

ARJ-45 connectors — See “Cabling the RJ-45 connectors”, on the next page.

NOTE: All RJ-45 connectors are teminated in accordance with the TIA/EIA T 568 A standard.

BAC power connector — Connect this cord to the power source.

NOTES: • For US domestic versions, this power cord is

permanently connected to the HSA. Connect the power cord to a 125 VAC, 60 Hz, 10 A power source.

• For international versions, this power cord is a removable IEC power cord. Connect the cord to a 220-250 V, 50-60 Hz, 10 A power source.

CCable access holes

DSpare AAP panel screws

ETop panel height adjustment screw — See “Adjusting the Height of the Top Surface” in the “Maintenance and Modifications” section.

Cabling the RJ-45 connectors

Plug one end of a CAT 6 twisted pair (TP) cable into each of these RJ-45 female connectors. Connect the other end to an appropriate telecommunications or data network or to an Extron TP product.

NOTE: All RJ-45 connectors are terminated in accordance with the TIA/EIA T 568 A standard.

When cabling the AAP panels and the bottom panel, the bottom RJ-45 connectors match up with the AAP panel RJ-45 connectors as shown in figure 9. For example, match the AAP panel RJ-45 connector A1 with the underside RJ-45 connector A1, match A2 with A2, and so forth.

A1	B1

A2	B2

Figure 9. HSA 822 RJ-45 Connectors

If necessary, replace the connector icon on the AAP panel by prying the old icon off of the connector plug-in with a tweeker or small screwdriver (see figure 10) and snapping a new icon in place.

Icon Labels

Figure 10. Changing the Connector Icon

12 HSA 822 Hideaway Enclosure • Installation

HSA 822 Hideaway Enclosure • Installation 13