Routing the AAP Cables, Bezels | Extron electronic HSA 822 specification

Routing the AAP Cables

The AAP cables must have freedom of movement to permit opening and closing the surface mount enclosure. At the same time, they need to be restrained to prevent them from rubbing against the edges of the enclosure cable access hole in the underside of the surface mount enclosure. Cables can be damaged by rubbing against the cable access hole edges. Route and secure the AAP cables as follows:

1.Open the top panel to extend the AAP cables to their maximum pull.

2.Experiment with AAP cable positioning to ensure that the cables do not rub against the edges of the AAP cable hole and to ensure that the cable pull does not restrict the movement of the top panel. Figure 11 shows the cables routed to the side, which proved effective in tests at Extron.

3.Use tie wraps to secure the AAP cables to the tie-down holes in the clamshell and enclosure in the locations shown on figure 11.

View from one side

View from the opposite side

Secure the AAP cables at the circled locations.

Figure 11. HSA 822 AAP Cable Routing

Bezels

The HSA 822 ships with RJ-45 connector bezel plug-ins in a variety of

Bezel colors and a black, blank bezel.

To change to a different color RJ-45 connector bezel or if an RJ-45 connector is not needed or desired, replace the connector bezel plug-in on the AAP panel with a bezel of a different color or a blank plug-in. See “Replacing the Bezels” in the "Maintenance and Modifications" section.

If no RJ-45 connector is desired, snap the
interior RJ-45 cable onto the rear of the
blank bezel plug-in (shown at right) to hold
it conveniently out of the way. Retain the
removed connector bezel plug-in for any
possible later use.	Blank Bezel
	Plug-in in AAP
	Panel

14 HSA 822 Hideaway Enclosure • Installation

HSA 822 Hideaway Enclosure • Installation 15