Installation Overview

Installation

This section describes installation of the HSA 822, including connections and features. Topics that are covered include:

•Installation Overview

•Preparing the Routing Template

•Preparing the Table and Mounting the Enclosure

•Cabling and Installing the AAPs

•Cabling the Enclosure

•Routing the AAP Cables

•Bezels

Install and set up the HSA 822 as follows:

If desired, install the optional flexible conduit kit to replace the removable AC power cord. Refer to the Flexible Conduit Kit Installation Guide.

If you have an unprepared mounting template, prepare the template. See “Preparing the Routing Template” on the next page.

Cut a hole in the surface where the enclosure will be installed and install the enclosure. The clamshell, a clamping and protective device, clamps the enclosure to the table. See “Preparing the Table and Mounting the Enclosure” on page 7.

Run all cables necessary to support the AC and RJ-45 connectors and all planned AAP connectors. Leave enough slack in the cables to connect them to the underside of the enclosure or to the rear of the AAPs before the AAPs are installed in the enclosure.

Turn off all of the equipment to be connected. Ensure that the equipment connected to the RJ-45 connectors and the connections for any AAPs are all turned off and disconnected from the power source.

If applicable, connect cables to the rear connectors on the AAPs to be installed in the HSA 822. Install the desired AAPs on the AAP panel of the enclosure. See “Cabling and Installing the AAPs” on page 10.

Connect the power and RJ-45 cables to the underside of the enclosure. See “Cabling the Enclosure” on page 12.

Route and secure the AAP cables inside the clamshell. See “Routing the AAP Cables” on page 14.

If present, peel the protective coating from the top surface.

Connect power cords and turn on the devices that connect to the HSA 822.

HSA 822 Hideaway Enclosure • Introduction

HSA 822 Hideaway Enclosure • Installation