Extron electronic MAV 84, MAV 88, MAV 44, MAV 48 manual Example 6 Save a preset, Preset 2 Preset

Example 6: Save a preset

The following steps show an example in which the current configuration is saved as a preset. The example shows the front panel indications that result from your actions.

1.	Press and hold the Preset button for approximately 2 seconds until the Preset
	LED begins blinking (figure 3-27).
Press and hold the button.
PRESET	PRESET

2 seconds

The LED blinks to indicate Save Preset mode.

Release the Preset button.

All input and output buttons with assigned presets light. If you then save the configuration to a lit preset number, the configuration data at that preset location will be overwritten.

				INPUTS						OUTPUTS
1	2	3	4	5	6	7	8	1	2	3	4

Preset 1 Preset 2	Preset 3 Preset 4 Preset 5 Preset 6 Preset 7 Preset 8	Preset 9 Preset 10 Preset 11 Preset 12
(Preset 2	(Preset 5	(Preset 9
assigned)	unassigned)	assigned)

= lit LED, = blinking LED, = unlit LED.

Figure 3-27 — Enter Save Preset mode, MAV 84

2. Press and release the Input 1 button (figure 3-28).

All LEDs but Input 1 and the Preset LED go out. The Input 1 LED and Preset LED remain lit for 1 second to indicate the saved preset number and then go out.

Press and release the Input 1 button to select preset 1.

1 2 3

Preset 2 Preset 3

All LEDs except the saved preset's LED go out.

			INPUTS	OUTPUTS
1	2	3	4	3	4	PRESET

The LED for the saved preset and the Preset LED remain lit for 1 second then go out.

Figure 3-28 — Select the preset

MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation 3-17