Extron electronic SVS 100 manual Executive Mode, System Reset, Advanced Menus, Output video type

Page 25

Executive Mode

The Executive mode allows all front panel controls to be disabled, except for the Input buttons. Pressing the Top and Bottom Blanking buttons simultaneously for two seconds will enable the Executive mode. While in the Executive mode, the RS-232/RS-422 port is still active and commands can still be issued to the SVS 100 using the Simple Instruction Set (see chapter 5, Serial Communication).

The Executive mode may be disabled by pressing the Top and Bottom Blanking buttons simultaneously for two seconds. The Executive mode may also be enabled/disabled through the RS-232/RS-422 port. The LCD will display whether the Executive mode has been enabled or disabled.

System Reset

To reset the entire SVS 100 to factory default settings, disconnect and reconnect the AC power cord to the SVS 100 while pressing down the Audio button. The LCD will display a system reset menu.

X-MODE ENABLED

X-MODE DISABLED

SYSTEM RESET

Advanced Menus

The Advanced menus of the SVS 100 offers menu control of output video type, Demo mode, input video type, and audio switching. To display the Advanced menus, simultaneously press the three Effects buttons (effect, transition, and duration) and follow the menus below.

Output video type

After initially pressing the three Effects buttons (as previously described), select the desired video output type by rotating the encoder knob. The choices are NTSC or PAL. If no button is pressed within 8 seconds, the SVS 100 exits the Advanced menus.

OUTPUT

NTSC

OUTPUT

PAL

Demo mode

After selecting an output video type (as previously described), the Demo mode may be selected by pressing the Audio button. The Demo mode will output a continuous random selection of the four inputs, one-at- a-time, in 1-second, 30-second, or 60-second intervals. Press the Audio button and rotate the encoder knob to either select an interval or select Off to disable the Demo mode. If no button is pressed within 8 seconds while Demo mode is Off, the SVS 100 exits the Advanced menus.

DEMO

OFF

DEMO 1 SEC

DEMO 30 SEC

DEMO 60 SEC

SVS 100 Operation

3-7

Page 24 Page 26
Image 25
Page 24 Page 26
Contents SVS Seamless Video SwitcherSafety Instructions English PrecautionsConsignes de Sécurité Français Sicherheitsanleitungen DeutschQuick Start SVS Connecting the SVSRack or Table/Wall Mounting Effects InputGenlock Picture ControlsTable of Contents Table of Contents, cont’d Introduction OneAbout the SVS IntroductionSVS 100 Introduction Four Ntsc or PAL video inputs SVS 100 FeaturesIntroduction, cont’d Two InstallationSVS 100 Installation InstallationMounting the SVS Table or wall mountingCabling and Rear Panel Views Power connectionRack mounting Video input and output connectionsAudio input and output connections Installation, cont’dGenlock connections Genlock and Vertical Interval SwitchingRS-232/RS-422 connection Genlock setup Superimposed waveforms Oscilloscope displaysVectorscope screen during horizontal phase adjustment Operation ThreeInput selection controls and indicators Front Panel Controls and IndicatorsOperation SVS 100 OperationExamples of switching effects Effects controls and indicatorsOperation, cont’d Picture controls and indicators Genlock controls and indicatorsEncoder knob Audio buttonSystem Reset Executive ModeDemo mode Advanced MenusVCR mode Audio switching methodInput video type Optimizing the Video and Audio Inputs Chroma settingOperation, cont’d Windows-based Control Program FourUsing the Software Installing the Windows-based Control SoftwareWindows-based Control Program SVS 100 Windows-based Control ProgramHelp Windows-based Control Program, cont’d Serial Communication FiveSerial Communication Remote Control Port RS-232/RS-422Host-to-SVS 100 Communication SVS 100 Serial CommunicationUsing the command/response table Serial Communication, cont’d Audio Switch Mode SVS 100 Communication Example responses to commandsReference Information AAppendixReference Information Saving and Recalling Input Configuration PresetsSpecial Applications SVS 100 AppendixRemoving the top cover Configuring the SVS 100 for RS-422Replacing the top cover Relocating the ribbon cable and setting the jumperSVS 100 Appendix Video input and loopout Specifications SVSGeneral SVS 100 Appendix FCC Class a Notice Extron’s Warranty Extron Electronics. All rights reserved
Related manuals
Manual 2 pages 10.59 Kb
Top Page Image Contents