Extron electronic SVS 100 manual Installation, Mounting the SVS, Table or wall mounting

Installation

Mounting the SVS 100

The SVS 100 Seamless Video Switcher comes with two sets of mounting brackets. One set is for mounting the switcher under a table or against a wall, and the other set is for rack mounting.

Table or wall mounting

The table/wall mounting brackets extend approximately 1/4” (6.3 mm) above the top surface of the SVS 100 enclosure. This design allows for an air space between the enclosure and the surface on which it is mounted. Table or wall mount the switcher as follows:

1. Attach the table/wall mount brackets to the switcher with eight #8 machine screws, provided (see figure 2-1).

two mounting screws on each side

rack-mount bracket

Drill pilot holes — 3/32” (2.4mm) diam. 1/4” (6.3 mm) deep

or

	table/
four #8 screws	wall-mount
on each side	bracket

1	IN
INPUT

IN

OUT

OUT

1.3A

-240V 100

Hz 50/60

		3
	INPUT	IN
2	IN	OUT
INPUT

IN

OUT

OUT

	4
INPUT	IN
	OUT

OUTPUT

A

C

B

GENLOCK

IN

-232/422 RS

R REMOTE

									1
								R	L	-
							1		+
									-
						L		-	+
					1	R	+
				L		+
			1	R	+	-
		L		+	-
	1	R	+	-
L		+	-
	+	-
+	-

OUT

Figure 2-1 — Mounting the SVS 100 Switcher

2. Hold the switcher with the attached brackets against the underside of the table or other furniture, or against the wall. Mark the location of the screw holes of the bracket on the mounting surface.

3. Drill 3/32” (2.4 mm) diameter pilot holes, 1/4” (6.3 mm) deep in the mounting surface at the marked screw locations.

4. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4” of the screw protrudes.

5. Align the mounting screws with the slots in the brackets and place the switcher against the surface, with the screws through the bracket slots.

6. Slide the switcher slightly forward or back, then tighten all four screws to secure the switcher in place.

2-2 SVS 100 Installation