Extron electronic 4LDXI, 4LQXI manual Choices made for this

to get the Menu Select Options (Menu #0).

Chapter 3 • Using the System 4xi Front Panel

Menu #6 is used to set up composite or separate horizontal and vertical sync for line-doubled/quadrupled images. Follow the numbers in the diagram and continue.

❶Press

❷Press or to get Menu #6 (LD Sync CFG).

❸Press to select this menu. There are four functions in this menu as displayed from the left selection

point. They are listed in the diagram. Use to move between the two

selection points, and then use or to show the choices, and leave your choice displayed before going to the next function.

❹From the left selection point, press or to choose one of the four functions.

❺ Press to step to the

second selection point

and press or to

change the selection

for that function. If the

display already shows

what you want, leave it

and go on. The

	SYSTEM 4LDxi		Power Up
	EXTRON V3.11		Display
	After 2-3	Displayed information
	second
		depends upon video
	delay
		type, audio level and
				Change Entry Point
Default		breakaway setting.
	->VID 01 RGBS			Change Selection
	->AUD 01 +00dB
				Accept/Save Selection
	1			Exit to Menu 0
				7
Go to	MENU SELECT
	0.EXIT
Menu 9

MENU SELECT 1.VID MODE CFG

MENU SELECT 2.AUD LEVEL CFG

MENU SELECT

3.HOST BAUDRATE Screen

MENU SELECT 4.RGB DELAY

choices made for this

example are circled.

❹Press to step back

to the left selection point. Repeat steps ❹ and ❺ until you have made all of your changes to this menu.

❻Press to save these settings and

press to go to Menu #0. From there you may step to another menu and start your next setup procedure, or exit.

MENU SELECT 5.SLAVE CFG

2

MENU SELECT 6. LD SYNC CFG

MENU SELECT 7.LD CFG

MENU SELECT 8.INFORMATION

MENU SELECT 9.SWITCH SLAVE

Go to

Men 0

4Select function and move cursor 4 functions, 2 choices each

3 5 Make selection 6

LD SYNC CFG >H/HVOUT=>CSYNC

4a - Select H/HVOUT =

5 Select H Only

4b - Select SERRA. =

5 Select PRESENT

4c - Select HOUT POL =

5 Select NEG

4d - Select VOUT POL =

5 Select NEG

*Only if configured as a Slave switcher

➐Press to exit Menu #0 and go to the Default Menu.

Figure 3-4. Example: Configuring System 4 Output Sync for Line Doubled/Quadrupled Sources

_______ A detailed explanation of each menu follows, beginning with Menu #0 .

3-5 Extron • System 4xi Switcher Series • User’s Manual