Extron electronic 200, 300C, 300S, 600, 800 user manual Installing the power module CC 300, 600

Installation, cont’d

Installing the power module (CC 300, 600, 800)

From the underside of the Cable Cubby, gently push the power module into the desired position at the desired elevation. Secure the power module into position with four Phillips head screws.

Installing the cables

Three half-moon cutouts in each set of cable pass-through (split) AAPs loosely channel three cables in the cubby. Each channel is padded with a split grommet to prevent cable wear. Each channel and each associated split grommet is a different size (figure 2-5).

	Large
Small	Small
	Medium
Medium	Medium
	Small
Large	Large

Cable hole	Hole size	Grommet size
Large	0.625" (1.59 cm)	0.453" (1.15 cm)
Medium	0.562" (1.43 cm)	0.390" (0.99 cm)
Small	0.5" (1.27 cm)	0.312" (0.79 cm)

Figure 2-5 — Cable pass-through AAPs

A typical installation consists of a VGA cable, an audio cable, and a network cable. In a typical installation, the VGA cable runs in the largest channel, the network cable runs in the middle (medium) channel, and the audio cable runs in the smaller channel. In a non-standard installation, just match the diameter of the cable to the size of the channel as best you can.

Install cables in the channels as follows:

1.	Remove a segment of a set of split AAPs by unscrewing
	the nuts on the underside of the bracket that fastens the
	plate to the shelf (CC 200) or shelf bracket (CC300, 600, or
	800) (figure 2-4, on page 2-7).
2.	Rest the cables in the half-moon cutouts of the split AAP
	segment still mounted on the shelf (CC 200) or shelf
	brackets (CC 300, 600, and 800). Place the cables so that
	the connectors that require inside Cable Cubby access
	protrude from the front (black side) of the split AAP
	segment.
3.	Insert the screws of the split AAP segment that you
	removed in step 1 through the holes in the shelf bracket.
	Ensure that the cables are free in the channels that the two
	split AAP segments form without being pinched where the
	two segments meet.
4.	Secure the split AAP segment to the shelf (CC 200) or shelf
	brackets (CC 300, 600, and 800) with the provided captive
	washers and #4-40 nuts.
5.	Slip the appropriate size split grommet over each cable
	with the flange of the grommet toward the connector
	that will be accessible inside the Cable Cubby. Snap the
	grommets into the channels.
6.	If applicable, snap the included hole plugs into unused
	channels in place of the split grommets.

Installing the AAPs

The split AAPs can be replaced with passive Extron AAPs.

Replace a set of split AAPs as follows:

1.	Remove the set of split AAPs to be replaced by unscrewing
	the nuts on the underside the shelf (CC 200) or shelf
	bracket (CC 300, 600, and 800) that fasten the plates to the
	bracket (figure 2-4, on page 2-7).
2.	Cable the rear of the AAP(s) to be installed before attaching
	the AAPs to the enclosure.
3.	Insert the screws of the AAPs through the holes in the shelf
	or shelf bracket. Secure the AAPs to the shelf brackets with
	the provided captive washers and #4-40 nuts.

2-8 Cable Cubby® Products • Installation Cable Cubby® Products • Installation 2-9