Extron electronic Cable Cubby 600 Mounting the Cable Cubby, Adjusting the cable position CC

Installation, cont’d

Installing the shelf assembly (CC 300, 600, 800)

From the underside of the Cable Cubby, gently push the AAP shelf assembly into the desired position at the desired elevation. Ensure there is enough space above the AAP assembly for the Cable Cubby lid to close completely. Secure the AAP shelf assembly into position with four Phillips head screws.

NIf the AAP shelf assembly does not slide easily into the cubby, loosen the AAP mounting nuts. Retighten the AAP mounting nuts once the AAP shelf assembly is installed in position.

Adjusting the cable position (CC 200)

The Cable Cubby 200 has three cable stand-offs (figure 2-6) that allow you to set the height of the cables inside the enclosure. Adjust the cable height as follows:

Cable Stand-Off

Loosen screws to adjust side to side.

Remove screws to adjust height.

Figure 2-6 — Cable Cubby 200 height adjustment

1.	Insert the stand-off into the Cable Cubby and align the
	stand-off with one set of horizontal slots in the side of the
	enclosure. Choose the adjustment height that best lifts the
	cable connectors off of the cable pass-through AAP and
	yet still allows the lid to be closed.
2.	Loosely install the Phillips head screws and washers as
	shown in figure 2-6.

3.	Install a second stand-off, in accordance with steps 1 and 2.
4.	Slide the stand-offs back and forth in the horizontal slots to
	position them so that the cables easily rise and lower but
	do not fall below the stand-offs.
5.	Tighten the Phillips head screws to lock the stand-offs into
	position.
6.	Install and position the third stand-off, in accordance with
	steps 1 and 2 and 4 and 5 to secure the remaining cables.

Mounting the Cable Cubby

WThe flanged edges of the top of the surface enclosure are sharp. Exercise caution when the cubby is not installed in a table to prevent personal injury.

CThe flanged edges of the top of the cubby are bevelled to an ultra-fine thickness of less than 0.04 (4/100)” (approximately 1 mm). These edges are soft and can be easily nicked or bent. Exercise caution when handling and mounting the enclosure. Mishandling can damage the appearance of the enclosure.

1. Cable Cubby 300, 600, and 800 — If screw clamps are installed, remove them from both sides of the enclosure (figure 2-7 on page 2-12).

NFigure 2-7 shows the installation of a Cable Cubby 300C. Cable Cubby

300S, 600, and 800 installations are similar.

2. Remove the plastic strips that protect the corners of the enclosure and the plastic film on the finished surfaces. If a sticky residue remains, remove it with an appropriate metal cleaning product.

CDo not use isopropyl alcohol or other solvents to clean the Cable Cubby. Strong solvents will ruin some finishes.

2-10 Cable Cubby® Products • Installation Cable Cubby® Products • Installation 2-11