Extron electronic Cable Cubby 200, Cable Cubby 600, Cable Cubby 800 Introduction, cont’d, Features

Introduction, cont’d

The installed Cable Cubbies fit nearly flush within a table or podium top, storing the AAPs and cables out of the way and out of sight. To access the AAPs and connectors, lift the lid (figure 1-2). Half-moon cutouts in the lid allow you to run cables in or out and then close the lid. For Cable Cubby 300s, 600s, and 800s, you can lower the lid into its recessed position.

Extron

Cable Cubby 800

Hideaway Cable

Access Enclosure

15-pin HD Cable

Audio Cable,

Network Cable

Mounted through a table or podium

Features

•Easy access to cables and AAPs

•Durable mechanical movement

•Cable Cubby 300, 600, and 800 available in a variety of surface finishes

•Compact size

•Flexible installation of Extron passive AAPs

•Grounded AC receptacle(s)

•UL/CUL listing

•CSA certification

Figure 1-2 — Typical Cable Cubby 800 application

The Cable Cubby 300 is available with either a round or a rectangular top. The other cubbies all have rectangular tops only. Preparing the table to install a Cable Cubby 300C (round) requires simply drilling a hole in the table with a 6-inch hole saw (figure 1-3). Preparing the table to install a square cubby requires routing a square hole in the table top. Sheet metal routing templates are available on request for all models at no cost.

1

2

3

Figure 1-3 — Cable Cubby 300C mounting

1-4 Cable Cubby® Products • Introduction Cable Cubby® Products • Introduction 1-5