Extron electronic 200, 300C, 300S, 600, 800 Reference Information, Installing the power module

Page 19

Maintenance and Modiﬁcations, cont’d

4From the underside of the Cable Cubby, gently push the additional power module into the desired position at the desired elevation. Secure the power module into position with the included four Phillips head screws (ﬁgure 3-7).

Extron

Cable Cubby 600

2 Screws ea. side

Figure 3-7 — Installing the power module

5If desired, assemble and install replacement AAP shelf assemblies. Remember that the cable pull function of the Cable Cubby requires at least two AAPs. See Installing the Cables and AAPs in chapter 2, Installation.

6If you removed the cubby from the table, reinstall the surface mount enclosure. See Removing and Replacing the Cable Cubby, steps 8 through 11, earlier in this chapter.

Cable Cubby® Products

AAppendix A

Reference Information

Speciﬁcations

Cable Cubby Part Numbers

Included Parts

Replacement/Modiﬁcation Part Numbers

Routing Template Part Numbers

Top Plate Dimensions

3-10 Cable Cubby® Products • Maintenance and Modiﬁcations

Image 19

Contents Cable Cubby Page Table of Contents Introduction Table of Contents, cont’dCable Cubby Products About the Cable Cubby Products IntroductionIntroduction, cont’d FeaturesTwo InstallationInstallation Overview InstallationPreparing the Routing Template Preparing the table with a router Installation, cont’d Preparing the TableAAP shelf brackets CC 300, 600 Installation, cont’dInstalling the Cables and AAPs Preparing the table with a hole saw Cable Cubby 300C onlyInstalling the cables Installing the power module CC 300, 600Installing the AAPs Adjusting the cable position CC Installing the shelf assembly CC 300, 600Mounting the Cable Cubby Cable Cubby 300C Maintenance and Modiﬁcations Removing and Replacing the Cable Cubby Maintenance and ModiﬁcationsReplacing Cables or an AAP Maintenance and Modiﬁcations, cont’dInternational Cable Cubby 600 with second power module Cable Cubby 600 with second power module Reference Information Installing the power moduleSpeciﬁcations Reference InformationGeneral Cable Cubby Packaging for Shipment, cont’dCable Cubby Part number Cable Cubby Part NumbersPackaging for Shipment, cont’d Included Parts Replacement/Modiﬁcation Part NumbersRouting Template Part Numbers Top Plate DimensionsCable Cubby Cable Cubby 300C Cable Cubby Packaging for ShipmentFigure B-1 Cable Cubby return kit Packaging for ShipmentFigure B-3 Removing center foam Figure B-7 Placing the cubby in the carton Packaging for Shipment, cont’d Packaging for Shipment Extron’s Warranty Precautions