Extron electronic Cable Cubby 800, Cable Cubby 600 user manual Figure B-3 Removing center foam

Packaging for Shipment, cont’d

Figure B-3 — Removing center foam

6. CC 600, 800 only — Remove and discard the inner side foam sections of the cushion in the carton (figure B-4). If you are returning a Cable Cubby 600 model, this is the correct fit. Proceed to step 8.

Figure B-4 — Removing inner side foams

7. CC 800 only — Remove and discard the outer side foam sections of the cushion in the carton (figure B-5). This is the correct fit for a Cable Cubby 800 model. Proceed to step 8.

Figure B-5 — Removing outer side foams

8. If you will not install a replacement Cable Cubby in this location, remove and retain one of the small foam sections to the front or rear of the cubby opening in the cushion in the carton (figure B-6).

Figure B-6 — Removing screw clamp area foam

9. CC 300, 600, 800 only — Place the two screw clamps from step 2 into the screw clamp opening in the foam cushion in the carton.

B-4 Cable Cubby® Products • Packaging for Shipment Cable Cubby® Products • Packaging for Shipment B-5