Installation, cont’d
3. Carefully lower the Cable Cubby into the hole to test the fit. If necessary, remove the enclosure and use a file or rasp to enlarge or smooth the edges of the opening (figure
Audio Cable | Cable Cubby 300C | |
Enclosure for Cables, AAPs & | ||
| ||
| AC Power Outlet |
Mounting
Surface
Screw Clamp
Figure 2-7 — Cable Cubby 300C, installation view
4. Cable Cubby 300, 600, and 800 — From the underside of the table, reinstall the screw clamps on the enclosure at a height at which the clamp will reach the underside of the tabletop.
CDo not overtighten the Phillips head screws on the screw clamps. Overtightening can bend the horizontal flange of the screw clamp.
5. Cable Cubby 300, 600, and 800 — Snugly tighten the Phillips head screws on the screw clamps to secure the enclosure to the surface.
6. Cable Cubby 300, 600, and 800 — Tighten the locking thumbscrews on the screw clamps to lock the clamp in position.
7. Cable Cubby 200 — Drill 1/8" (3 mm) pilot holes ½"
(12 mm) deep into the table in the mounting holes at each of the four corners of the cubby.
8. Cable Cubby 200 — Use the four included
screws to fasten the Cable Cubby 200 to the table (figure
Figure 2-8 — Cable Cubby, installation view
Cable Cubby® Products • Installation |