Extron electronic DTP T UWP 232/332 D manual Installation Operation, Mounting the Transmitter

Installation and

Operation

This section describes the installation and the operation of the extenders, including:

•Mounting the Transmitter

•DTP T HWP 232 and 332 D Connections

•DTP T UWP 232 and 332 D Connections

•TP Cable Termination and Recommendations

•Power Supply Wiring

•RS-232 and IR Connector Wiring

•Operation

Mounting the Transmitter

ATTENTION:

•Installation and service must be performed by authorized personnel.

•The installation must conform to national and local building, electrical, and safety codes and to the size requirements of the wall plate.

The transmitters can be installed in a two-gang electrical wall box, or with a mud ring, with a Decora wall plate cover (supplied).

UL and Safety Guidelines

The following UL guidelines pertain to the installation of the Decora transmitters into a wall or furniture.

•These units are not to be connected to a centralized DC power source or used beyond their rated voltage range.

•These units must be installed in UL Listed wall boxes.

•These units must be installed with conduit in accordance with National Electrical Code.

DTP T HWP/UWP 232/332 D Transmitters • Installation and Operation 4