Extron electronic DTP T HWP 232/332 D, DTP T UWP 232/332 D Transmitter LEDs, System Operation

Operation

A

B C

AUTO SW A AUTO SW

AUDIO IN	HDCP	AUDIO IN	B	AUDIO IN	HDCP	AUDIO IN
	1				1
HDMI IN	2	HDMI IN	C	HDMI IN		VGA IN

CONFIG	CONFIG
IR OUT	IR OUT

S	S
G	G

Extron Extron

DTP T HWP 232/332 D	DTP T UWP 232/332 D
Front Panel	Front Panel
Figure 14. Transmitter LED Indicators

Transmitter LEDs

APower LEDs — Two-color front panel LEDs on the transmitters light to indicate signal and power status as follows:

Amber — The unit is receiving power but there is no signal on the associated input.

Green — The unit is receiving power and a signal is present on the associated input.

NOTE: Both inputs on the transmitters have their own separate LEDs.

BAuto Switch LED — Lights green when auto switch is active (see “Contact” of item C on pages 9 and 11).

CHDCP LEDs — Lights green when HDMI input has been authenticated on the source device.

System Operation

After the transmitter, the receiver, and their connected devices are powered up, the system is fully operational. If any problems are encountered, ensure all cables are routed and connected properly.

NOTES:

•Ensure that the video source and display are properly connected to the transmitter and receiver pair, and that the transmitter, the receiver, and the display have power applied before power is applied to the video source. If all other devices are not turned on before the video source, the image may not appear.

•Input switching can only be performed via auto switching, RS-232, or contact closure through the rear panel connectors.

DTP T HWP/UWP 232/332 D Transmitters • Installation and Operation 15