Mud Ring Installation

6.Feed the twisted pair cables and, if applicable, the power cables through the opening and through the wall box punch-out holes, securing them with cable clamps to provide strain relief.

NOTES:

• In order to fit in the wall box, the twisted pair cables and RJ-45 connectors should not have a boot installed.

•One power supply can power both the transmitter and the receiver, so only one unit needs a power supply (see Power Supply Wiring on page 13).

7.Trim back and insulate exposed cable shields with heat shrink to reduce the chance of short circuits.

To prevent short circuits, the outer foil shield can be cut back to the point where the cable exits the cable clamp.

8.Connect the cables to the rear of the unit.

9.Connect front panel devices (see “Front Panel” on pages 8 and 10 for connector details), restore the power supply, and test the transmitter and receiver system. Make any cabling adjustments before final installation, as the cables will be inaccessible afterwards.

1.Using the mud ring as a guide, mark the edges and cut out the material within the marked area.

2.Insert the mud ring into the opening, rotate and secure the locking arms with the supplied screws shown in figure 3.

3.Follow steps 6 through 9 of “Site preparation and wall box installation” above, and Final Installation on the next page.

Wall

Wall Mounting

Mudring

Figure 3. Installing the Mud Ring

DTP T HWP/UWP 232/332 D Transmitters • Installation and Operation