Tripp Lite SU10KRT3U, SU6000RT3UXR Bypass Messages, Shutdown Messages, Conditions Messages

Operation continued

Bypass Messages

While in Bypass Mode, the UPS monitors its input voltage and passes that input power along to connected equipment. The UPS will not provide battery backup in Bypass Mode.

If the output voltage deviates from an acceptable range (between 15% higher and 20% lower than nominal), the UPS displays the condition on its LCD and stops supplying output power to its load. If power levels return to an acceptable level, the UPS resumes supplying power to the load, and its LCD reports that output voltage was too high or too low at one time, but has returned to nominal.

BYPASS VOLTAGE	LCD DISPLAY
CONDITIONS	MESSAGES
>15% Higher
	NO OUTPUT
Than Nominal	BYPASS AC TOO HI
>20% Lower
	NO OUTPUT
Than Nominal	BYPASS AC TOO LO
Was Too High,	BYPASS MODE
Now Nominal	BYPASS AC WAS HI
Was Too Low,	BYPASS MODE
Now Nominal	BYPASS AC WAS LO

Shutdown Messages

Your UPS will shut down and the LCD will display a message if it detects one of the following conditions. Note: During all these conditions, the “Input,” “Output” and “Bypass” LEDs will be illuminated.

SHUTDOWN	LCD DISPLAY
CONDITIONS	MESSAGES
Extended	SHUT DOWN
Overload	OVERLOAD XXX%
Output Short	SHUT DOWN
Circuit	O/P SHORT CIRCUIT
Remote Shutdown	SHUT DOWN
Command (Via DB9)	REMOTE COMMAND
Remote Shutdown	SHUT DOWN
Command (Via EPO)	EMERGENCY STOP!
Internal	SHUT DOWN
Faults	+ DC BUS HIGH
	SHUT DOWN
	+ DC BUS LOW
	SHUT DOWN
	- DC BUS HIGH
	SHUT DOWN
	- DC BUS LOW
	SHUT DOWN
	OVERTEMPERATURE

18