Q-Logic 2300 manual Selecting the Boot Device

￿	3 – QLA2342/2342L
	FCode

Use the set-data-rate command to change the current QLA2342/2342L Fibre Channel data rate. For example:

ok 1 set-data-rate

Calculating NVRAM checksum, please wait...

Current HBA data rate: Two Gigabit rate

Table 3-6lists the values to enter and their corresponding data rates. QLogic recommends the Auto-negotiated rate (2), which works for most devices.

Table 3-6. Fibre Channel Data Rates

Value Data Rate

0One gigabit

1Two gigabits

2Auto-negotiated rate

3.4.5

Selecting the Boot Device

Perform the following steps to select a Fibre Channel device that is attached to the QLA2342/2342L HBA as the boot device:

1.Use the show-devscommand to display the device tree for all devices attached to the machine.

ok show-devs

The device tree displays. The QLA2342/2342L HBAs with FCode are referenced with QLGC,qla@. For example:

ok show-devs

.

.

/pci@1f,0/pci@1/QLGC,qla@4

2.Select the QLA2342/2342L HBA attached to the Fibre Channel device from which you want to boot. For example, type the following at the ok prompt:

ok " /pci@1f,0/pci@1/QLGC,qla@4" select-dev

3.Use the show-childrencommand to view the devices attached to the QLA2342/2342L HBA. For example:

ok show-children

4.The list of devices displays. Write down the boot device’s world wide name (WWN), loop ID, and logical unit number (LUN).

5.Save the boot device information to the QLA2342/2342L HBA’s NVRAM. Use the set-boot-idcommand. Include the selected QLA2342/2342L HBA’s WWN, loop ID, and LUN. For example:

ok 2200002037009eeb 82 0 set-boot-id

FC2354601-00 A 3-15