5 – Windows NT Driver Installation | |
QL2x00IP NDIS Network Driver Installation |
■Header Split Size. This parameter accounts for packets with split headers and data. The parameter value specifies the number of bytes at the beginning of an incoming packet that must be isolated in the first receive buffer. A value of 0 indicates that the packet header and data are not split. QLogic recommends a default value of 0.
■Adapter Node Name. This parameter specifies the world wide name (node name) of the QLA23xx HBA to use for this IP connection. The parameter is required on systems with more than one QLA23xx HBA. You can use Fast!UTIL to determine the node names for all QLA22xx/QLA23xx HBAs in the system (see the Fast!UTIL section that corresponds to your QLA23xx HBA).
Perform the following steps to modify the QL2x00IP NDIS driver configuration:
1.Click the Start button, point to Settings, and click Control Panel.
2.
3.Make configuration parameter modifications as necessary.
4.Click OK. The Network dialog box redisplays.
5.Click Close.
6.Click Yes to restart the computer.
5.5.3.2
IP Address Configuration
Perform the following steps to modify the IP address:
1.Click the Start button, point to Settings, and click Control Panel.
2.
3.On the IP Address tab, select the QLA23xx HBA, then modify the IP address and subnet mask as appropriate. Each IP address must be unique and all QLA22xx/QLA23xx HBAs on the loop must use the same subnet mask. For example:
Adapter 1
IP address: 10.0.0.1
Subnet mask:255.255.0.0
Adapter 2
IP address: 10.0.0.2
Subnet mask:255.255.0.0
4. Click OK. The Network dialog box redisplays.
|