Moxa Technologies DE-211 manual Ethernet Installation, Connecting to the Ethernet Port

Page 25

4

Ethernet Installation

We discuss the following topics:

¾Connecting to the Ethernet Port

•Connecting to a Hub or Switch

•Connecting to a PC

Connecting to the Ethernet Port

Connecting to a Hub or Switch

For most applications, you will simply plug one end of your Ethernet cable into NPort Express’s 10BaseT port, and the other end into a Hub or Switch that is connected to your network. In this case, you should use a standard straight-through Ethernet cable, which is readily available from many commercial vendors. If necessary however, you can make your own cable by referring to the following cable wiring diagram.

Image 25

Contents NPort Express NPort Express Moxa Internet Services Table of Contents Introduction Product Specifications FeaturesOS Supported Package Checklist Front/Top/Rear/Bottom Panel Views Page Overview LED IndicatorsDIN Rail HousingWall Mount Page DIP Switch Settings Serial InstallationRS-232 Console Female DB25 Connector PinoutRS-232 Wiring Page Using a DB25 Connector Using the Optional Terminal Block RS-422 WiringUsing a DB25 Connector RS-485 WiringWire RS-485 Terminal Block Wiring Enabling a Termination Resistor Enabling the Built-In 120 Ω Terminator Enabling a User-Supplied Terminator Connecting to the Ethernet Port Ethernet InstallationConnecting to a Hub or Switch Connecting to a PC Using the Power Adapter Power ConnectionImportant Notice Using Power Over SerialPower Status Check Page EMC Declaration of ConformityPage NPort Express Problem Report FormPage Return Procedure