Schneider Electric 3000 Bypass Led Illuminates, Fault Led Illuminates, Diagnostic Utility Voltage

PROBLEM AND POSSIBLE	SOLUTION
CAUSE
BYPASS LED ILLUMINATES
The bypass switch has been	If bypass is the chosen mode of operation, ignore the illuminated LED.
turned on manually or through	If bypass is not the chosen mode of operation move the bypass switch on the
an accessory.
	back of the UPS, to the normal position.
FAULT AND OVERLOAD LEDS ILLUMINATE, UPS EMITS A SUSTAINED ALARM TONE
The UPS has ceased sending	The connected equipment exceeds the specified “maximum load” as defined in
power to connected equipment.	Specifications on the APC Web site, www.apc.com.
	Disconnect nonessential equipment from the UPS to eliminate the overload
	condition.
	Press the OFF button, then the ON button to restore power to connected
	equipment.
FAULT LED ILLUMINATES
Internal UPS fault.	Do not attempt to use the UPS. Turn the UPS off and have it serviced
	immediately.
REPLACE BATTERY LED ILLUMINATES
Replace Battery LED flashes and	Check that the battery connectors are fully engaged.
short beep is emitted every two
seconds to indicate the battery is
disconnected.
Weak battery.	Allow the battery to recharge for 24 hours. Then, perform a self-test. If the
	problem persists after recharging, replace the battery.
Failure of a battery self-test.	The UPS emits short beeps for one minute and the Replace Battery LED
	illuminates. The UPS repeats the alarm every five hours. Perform the self-test
	procedure after the battery has charged for 24 hours to confirm the Replace
	Battery condition. The alarm stops and the LED clears if the battery passes the
	self-test.
UPS OPERATES ON BATTERY ALTHOUGH NORMAL LINE VOLTAGE EXISTS
Very high, low, or distorted line	Move the UPS to a different outlet on a different circuit. Test the input voltage
voltage. Inexpensive fuel	with the utility voltage display.
powered generators can distort
the voltage.
DIAGNOSTIC UTILITY VOLTAGE
All five LEDs are illuminated	The line voltage is extremely high and should be checked by an electrician.
There is no LED illumination	If the UPS is plugged into a properly functioning utility power outlet, the line
	voltage is extremely low.
ONLINE LED
There is no LED illumination	The UPS is running on battery, or it is not turned on.
The LED is blinking	The UPS is running an internal self-test.

.

15