Schneider Electric 3000, 5000 user manual Avoid using extension cords

Page 7

CONNECTING EQUIPMENT AND POWER TO THE UPS

1.Connect equipment to the UPS (cables not included for XLJ/XLT/XLTW models).

2.Avoid using extension cords.

3000 VA XLJ/XLT/XLTW/XLI and 5000/6000 VA XLJ/XLT/XLTW models: Using a power cord, plug the UPS into a two-pole,three-wire, grounded receptacle only.

5000/6000 VA XLJ and 6000 VA XLT models: To draw full power from the UPS have a qualified electrician cut off the input plug and hardwire the UPS to the appropriate power panel.

3.Turn on all connected equipment. To use the UPS as a master ON/OFF switch, ensure all connected equipment is switched ON. The equipment will not be powered until the UPS is turned on.

4.To power up the UPS press the 2.Avoid using extension cords. button on the front panel.

The UPS battery charges when it is connected to utility power. The battery charges to 90% capacity during the first three hours of normal operation. Do not expect full battery run capability during this initial charge period.

5.For additional computer system security, install PowerChute® Business Edition Smart-UPS monitoring software.

OPTIONS

Refer to the APC Web site, www.apc.com for available accessories.

‰External Battery Pack SURT192XLBP

‰Rail Kit SURTRK2

‰Isolation Transformer

‰Service Bypass Panel

.

5

Image 7
Contents User Manual Uninterruptible Power Supply3000/5000/6000 VA 200-240 Vac Tower/Rack Mount 3U Smart-UPS RTPage Introduction SpecificationsINSTALLATION Read the Safety Guide before installing the UPSWiring and Connecting the UPS CONNECTING THE BATTERY MODULES AND ATTACHING THE FRONT BEZEL Use only interface kits supplied or approved by APC connectorWhen connecting grounding cable, disconnect the unit from the utility power outlet2. Avoid using extension cords OPERATION The UPS starts a self-test as part of this procedure. The self-test On Battery Operationdoes not affect the voltage display FACTORY USER CONFIGURABLE ITEMSDEFAULT FUNCTIONAdhere to National and local electrical codes when wiring the EPO 9 bits per second 9 data - bits 9 parity - none 9 stop bit Services9 flow control - none 5000/6000 VA models X YZ \ Replacing the Battery ModuleMAINTENANCE AND TRANSPORT Be careful during battery replacement, the battery modules are heavyThe batterys may remain in the UPS Disconnecting the Battery for TransportREPLACING BATTERY MODULES CAUSE TROUBLESHOOTING, SERVICE, AND WARRANTY INFORMATIONPROBLEM AND POSSIBLE SOLUTIONUPS OPERATES ON BATTERY ALTHOUGH NORMAL LINE VOLTAGE EXISTS FAULT AND OVERLOAD LEDS ILLUMINATE, UPS EMITS A SUSTAINED ALARM TONEFAULT LED ILLUMINATES REPLACE BATTERY LED ILLUMINATESLimited Warranty ServiceRadio Frequency Warnings APC Worldwide Customer SupportREGULATORY
Related manuals
Manual 17 pages 55.36 Kb