Network Technologies ST-xU operation manual Trademark

Page 2

TRADEMARK

NODEMUX is a registered trademark of Network Technologies Inc in the U.S. and other countries

COPYRIGHT

Copyright © 2005 by Network Technologies Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202.

CHANGES

The material in this guide is for information only and is subject to change without notice. Network Technologies Inc reserves the right to make changes in the product design without reservation and without notification to its users.

i

MAN064 Rev Date11/10/2005

Image 2
Contents ST- xU Trademark Table of Contents Table of Figures Available Options FeaturesIntroduction Supported DevicesMaterials Materials SuppliedFeatures and Functions Rackmounting Instructions To Mount to a RackInstallation Dip-switch configurationConnect a PS/2 keyboard and mouse For each CPU Connect a PS/2 CPUSuncpu For Units with Touch-screen support -TSO option Connect a touch-screen monitor to an ST-8U-TS-RCascading LimitationsConfiguration Cascaded InstallationBasic cascaded master-to-slave cable connections Cable RequiredFront Panel Control Basic Command ModeOperation Keyboard ControlBroadcast Mode LED will toggle on and OFF Command Functions Contd Function KeystrokeScan Mode LED will toggle on and OFF Xxx from 002 to 255. ie. t002Security Option Enabling the Security FeatureOSD Control Additional Modes Available With Security User Login ModeAdministration Mode Switch Configuration Configure for CascadingTab Administrator PasswordExit Switch Configuration Mode OSD Command Mode User Access FunctionsSystem Access List User Name ListCommand Mode menus Ctrl + E Ctrl + M Ctrl + OCommand Mode Cont’d FunctionKeystroke Edit Mode Edit ModeSearch Mode Esc EnterMaintenance Mode Activate security featuresOSD Touch Screen Support Touch Maintenance ModeHelp Mode OSD Entry Method Reset Default ValuesAlign The Cursor RS232 Connector DB-9 Female RS232 Connections and ConfigurationConfiguration via Dip Switches Remote ConnectionConfiguration via OSD Unit Address and Loop BackLoop Back Unit AddressCommand Protocol Pinout of Matrix-Y-1 cableFormat RU Aacr KEYBOARD-TO-CPU Translation Keyboard key layoutsHOW to Disable Operating Modes Location of jumper blockFor models ST-xU no OSD Case screws must be removedClear access to the jumper block For models ST-xU-O with OSD Component layout in unit with OSD Optional-4 and 8 port models only Configuring the Jumper BlockNON-OSD Touch Screen Support Always turn power on in this sequence TroubleshootingWarranty Information