Network Technologies ST-xU operation manual Maintenance Mode, Activate security features

Page 28

NTI NODEMUX SERIES UNIVERSAL KVM SWITCH

Maintenance Mode

Maintenance Mode allows a user to customize the On Screen Display to their requirements

Function:Keystroke:

Reset all of the port names

R

 

Toggle between numeric and

L

alphabetic listing of ports

Move On Screen Display (OSD) window up on monitor

Move OSD window down on monitor

Move OSD window to the right

Move OSD window to the left

 

Make OSD window taller

T

Make OSD window shorter

S

Change user password.

P

(Present only when a standard

user is logged in.)

 

Log current user out and return

Q

to User Login Mode.

Activate security features.

 

Present only when security is

A

available but not active.

 

Enter Administration Mode.

 

Option present only when administrator

 

is logged in.

 

Save OSD window parameters

Enter

for the port

 

Return to Command Mode

Esc

 

Figure 26- Maintenance Mode

NOTE: If activating security features, the user will be prompted for a “Y” (yes) or “N” (no) to confirm the menu choice, at which point the user will be asked for a username and password before continuing. Only the administrator can activate the security features.

24

Image 28
Contents ST- xU Trademark Table of Contents Table of Figures Features IntroductionAvailable Options Supported DevicesMaterials Materials SuppliedFeatures and Functions Rackmounting Instructions To Mount to a RackInstallation Dip-switch configurationConnect a PS/2 keyboard and mouse For each CPU Connect a PS/2 CPUSuncpu For Units with Touch-screen support -TSO option Connect a touch-screen monitor to an ST-8U-TS-RCascading LimitationsConfiguration Cascaded InstallationBasic cascaded master-to-slave cable connections Cable RequiredBasic Command Mode OperationFront Panel Control Keyboard ControlCommand Functions Contd Function Keystroke Scan Mode LED will toggle on and OFFBroadcast Mode LED will toggle on and OFF Xxx from 002 to 255. ie. t002OSD Control Enabling the Security FeatureSecurity Option Administration Mode User Login ModeAdditional Modes Available With Security Switch Configuration Configure for CascadingExit Switch Configuration Mode Administrator PasswordTab User Access Functions System Access ListOSD Command Mode User Name ListCommand Mode menus Ctrl + E Ctrl + M Ctrl + OCommand Mode Cont’d FunctionKeystroke Edit Mode Edit ModeSearch Mode Esc EnterMaintenance Mode Activate security featuresHelp Mode Touch Maintenance ModeOSD Touch Screen Support Align The Cursor Reset Default ValuesOSD Entry Method RS232 Connections and Configuration Configuration via Dip SwitchesRS232 Connector DB-9 Female Remote ConnectionConfiguration via OSD Unit Address and Loop BackLoop Back Unit AddressCommand Protocol Pinout of Matrix-Y-1 cableFormat RU Aacr KEYBOARD-TO-CPU Translation Keyboard key layoutsHOW to Disable Operating Modes Location of jumper blockFor models ST-xU no OSD Case screws must be removedClear access to the jumper block For models ST-xU-O with OSD Component layout in unit with OSD NON-OSD Touch Screen Support Configuring the Jumper BlockOptional-4 and 8 port models only Warranty Information TroubleshootingAlways turn power on in this sequence