Network Technologies ST-xU operation manual Command Mode menus, Ctrl + E Ctrl + M Ctrl + O

Page 24

NTI NODEMUX SERIES UNIVERSAL KVM SWITCH

The On Screen Display menu will automatically appear on the monitor in addition to illuminating the indicator LEDs on the KVM switch. This provides a visual way to control the NODEMUX using the keyboard, monitor, and mouse.

With Touch Screen support (optional), the OSD menu can be entered by tapping 3 times on the monitor.

The list below describes the Command functions available from the keyboard within the OSD menu after entering into Command Mode and while the COMMAND LED is illuminated:

Function:Keystroke:

Select the previous port

Select the next port

Enable/disable Scan Mode	Ctrl
Enable/disable Broadcast Mode	Ctrl
Enable/disable Broadcast Mode

+S

+B

Figure 22- Command Mode menus

Enter Edit Mode

Enter Maintenance Mode

Enter Touch Maintenance Mode (only if the Touch Screen option is installed)

Display Help Menu (available with every control mode)

Ctrl + E

Ctrl + M

Ctrl + O

F1

See Touch Screen Support option on page 25 for more on Touch Maintenance Mode

20

Image 24

Contents ST- xU Trademark Table of Contents Table of Figures Features IntroductionAvailable Options Supported DevicesMaterials Materials SuppliedFeatures and Functions Rackmounting Instructions To Mount to a RackInstallation Dip-switch configurationConnect a PS/2 keyboard and mouse For each CPU Connect a PS/2 CPUSuncpu For Units with Touch-screen support -TSO option Connect a touch-screen monitor to an ST-8U-TS-RCascading LimitationsConfiguration Cascaded InstallationBasic cascaded master-to-slave cable connections Cable RequiredBasic Command Mode OperationFront Panel Control Keyboard ControlCommand Functions Contd Function Keystroke Scan Mode LED will toggle on and OFFBroadcast Mode LED will toggle on and OFF Xxx from 002 to 255. ie. t002Enabling the Security Feature OSD ControlSecurity Option User Login Mode Administration ModeAdditional Modes Available With Security Switch Configuration Configure for CascadingAdministrator Password Exit Switch Configuration ModeTab User Access Functions System Access ListOSD Command Mode User Name ListCommand Mode menus Ctrl + E Ctrl + M Ctrl + OCommand Mode Cont’d FunctionKeystroke Edit Mode Edit ModeSearch Mode Esc EnterMaintenance Mode Activate security featuresTouch Maintenance Mode Help ModeOSD Touch Screen Support Reset Default Values Align The CursorOSD Entry Method RS232 Connections and Configuration Configuration via Dip SwitchesRS232 Connector DB-9 Female Remote ConnectionConfiguration via OSD Unit Address and Loop BackLoop Back Unit AddressCommand Protocol Pinout of Matrix-Y-1 cableFormat RU Aacr KEYBOARD-TO-CPU Translation Keyboard key layoutsHOW to Disable Operating Modes Location of jumper blockFor models ST-xU no OSD Case screws must be removedClear access to the jumper block For models ST-xU-O with OSD Component layout in unit with OSD Configuring the Jumper Block NON-OSD Touch Screen SupportOptional-4 and 8 port models only Troubleshooting Warranty InformationAlways turn power on in this sequence