Quatech QSP-100 user manual OS/2 Installation, Drive\path\QSP100.SYS options

3. OS/2 Installation

In order to use the QSP-100 Client Driver for OS/2, the system must be configured as follows:

1.The system must be running OS/2 2.1 or later.

2.OS/2 PCMCIA Card and Socket Services support must be installed. If PCMCIA support was not selected when OS/2 was installed, it can be added using the Selective Install facility in the System Setup folder. On OS/2 2.1 and 2.11, Socket Services must be added separately. The necessary files can be found on Compuserve in the OS2SUPPORT forum and may be available elsewhere. These files are not available from Quatech Inc.

3.Quatech's OS/2 serial port device driver, "QCOM" version 2.01 or later, must be installed. The QSP-100 will not operate with the standard OS/2 serial port device drivers. Quatech Inc. can not guarantee the operation of the QSP-100 with any other third party device drivers for OS/2.

4.There must be at least 32 bytes of available I/O space and 1 available IRQ.

After the system has been configured to the above specifications, the QSP-100 Client Driver may be installed with the following procedure:

1.Copy the QSP100.SYS client driver file from the distribution Quatech COM CD to any convenient directory on the hard disk.

2.Open the CONFIG.SYS file using any ASCII text editor.

3.Add the following line to the CONFIG.SYS file:

DEVICE =

drive:\path\QSP100.SYS options

where options are the QSP-100 OS/2 Client

Driver command line options discussed in the following sections.

4.Save the CONFIG.SYS file, exit the text editor, shutdown the system, and reboot to activate the changes.

QSP-100 Users Manual 17